Measurements needed
1 Seat
2 Full length
3 Crotch depth=Sit on a hard chair and measure at the side from the waist to the chair seat .
or 1/4th of seat +4"
4 Leg round
Waist band
A-B=seat/2 + 1½” or to taste depending upon the fitting needed.
A-C =Seat/6 +2”.
Side panel
E-G =full length –length of the waistband +2½”.
Mark point I such that E-I = E-G – 3”.
Draw perpendiculars from E, I and G.
E-F =panel width=Leg round + 2 to 4” depending upon the built of the person.
I – J = E-F.
G-H =leg round/2 + 1”. Join F-G-and H.
Kali
K-M = F-J of the side Panel.
K-O = crotch depth - waist band length + 1”.
Draw perpendicular from K and O.
K-L = width of the material used for stitching.
O-N = K-L .Join L and N. Join M-N by curved line as shown in the figure.
prepare the draft Place the draft on the fabric as shown in the layout in Figure 2 and cut the pattern pieces. Cut kali along the line K-M and separate
Pattern pieces
Waist band -2nos
Side panels –2 no’s
Kali-4 nos
Stitching
Turn in 2” of the leg round H-G-H’, and stitch sandwiching 1½” of canvas in between the folds
Take one of the side panel and attach kali on either side as shown in the figure 4. Do the same thing for the other side panel.
Fold this into half along the line E-G, keeping right sides together and stitch the curve M-N as shown in the figure 5Stitch the other leg portion also in the same manner.
Keeping right sides together join these two leg portions at the crotch line as shown in the figure 6.
Join the two pieces of the waist band. Keeping right sides together pin front crotch seam ( select any one ) to front waist band seem(select any one). and back crotch seem to back waist band seem. Attach each leg portion with the waist band by taking pleats of equal width .The pleats should start from the centre of the front portion of the waist band and extend upto the centre of the back of the waist band. The pleats of each leg portion should be facing each other.
Fold the other edge of the waste band by 1” and prepare casing for the draw string.
